主页EIPs周刊
EIPsEIP-7609
EIP-7609

Decrease base cost of TLOAD/TSTORE

Improve the efficiency of TLOAD/TSTORE by decreasing the base cost and introducing a superlinear pricing model.
DraftStandards Track: Core
创建时间: 2024-02-01
关联 EIP: EIP-1153
Charles Cooper (@charles-cooper), James Prestwich (@prestwich), brockelmore (@brockelmore)
社区讨论原文链接编辑
1 分钟了解
欢迎补充好内容
去提交
相关视频
欢迎补充好内容
去提交
正文

Abstract

Decrease the base cost of TLOAD/TSTORE while introducing a superlinear pricing model. This increases the efficiency of TLOAD/TSTORE for common use cases, while providing a pricing model to prevent DoS vectors.

Motivation

EIP-1153 introduces a new storage region, termed "transient storage". It behaves like storage (word-addressed and persists between call frames), but unlike storage it is wiped at the end of each transaction. During development of EIP-1153, the pricing was set to be the same as warm storage loads and stores. This was for two reasons: conceptual simplicity of the EIP, and it also addressed concerns about two related DoS vectors: being able to allocate too much transient storage, and the cost of rolling back state in the case of reverts.

One of the most important use cases that EIP-1153 enables is cheap reentrancy protection. In fact, if transient storage is cheap enough for the first few slots, reentrancy protection can be enabled by default at the language level without too much burden to users, while simultaneously preventing the largest—and most expensive—class of smart contract vulnerabilities.

Furthermore, it seems that transient storage is fundamentally overpriced. Its pricing does not interact with refunds, it only requires a new allocation on contract load (as opposed to memory, which requires a fresh allocation on every call), and has no interaction with the physical database.

This EIP proposes a pricing model which charges additional gas per allocation, which is cheaper for common cases (fewer than ~95 slots are written per contract), while making DoS using transient storage prohibitively expensive.

Specification

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 and RFC 8174.

The gas cost for TLOAD is proposed to be 5 gas. The gas cost for TSTORE is proposed to be 8 gas + expansion_cost, where expansion_cost is calculated as 1 gas * len(transient storage mapping) if the key is not yet in the transient storage mapping, and otherwise 0 gas.

In pseudo-code:

G_LOW = 5 G_MID = 8 SLOPE = 1 def gas_tload(_key): return G_LOW def gas_tstore(key, transient_mapping): cost = G_MID if key not in transient_mapping: cost += SLOPE * transient_mapping.size() return cost

Rationale

Gas

In benchmarking, TLOAD was found to cost a similar amount of CPU time as MUL, while TSTORE was found to cost about 1.5x that. The values G_low and G_mid were therefore chosen for TLOAD and TSTORE, respectively.

Backwards Compatibility

No backward compatibility issues found.

Security Considerations

The maximum number of transient slots which can be allocated on a single contract given 30m gas is approximately 7,739 (solution to x(x-1)/2*1 + 8*x = 30_000_000), which totals 248KB.

The maximum number of transient slots which can be allocated in a transaction if you use the strategy of calling new contracts (which each are designed to maximize transient storage allocation) once the cost of TSTORE is more than the cost of calling a cold contract (2600 gas), can be solved for as follows:

solve for SLOPE * <num slots> == 2600, => num_slots == 2600
gas_used_by_contract = 2600 + SLOPE * num_slots * (num_slots - 1) / 2 + G_MID * num_slots == 3402100
block_gas_limit = 30_000_000
num_calls_per_txn = block_gas_limit // gas_used_by_contract ~= 8.8
max_transient_slots = num_calls_per_txn * num_slots == 22927

Thus, the maximum number of transient slots which can be allocated in a single transaction with this method is roughly 23,000, which totals 736KB. Compared to the current gas schedule (which allows allocating approximately 30_000_000 / 100 * 32 == 9.6MB worth of memory), this is a net reduction in the total memory which can be allocated on a client using transient storage, so this EIP presents a stronger bound on the resources which can be used by transient storage. As a comparison point, the total amount of memory which can be allocated on a client by SSTOREs in a given transaction is 30_000_000 / 20_000 * 32, or 48KB.

Note that this cap scales linearly with the gas limit, which is a useful property when considering future block gas limit increases.

Copyright and related rights waived via CC0.

扩展阅读
欢迎补充好内容
去提交
相关项目
欢迎补充好内容
去提交

不想错过最新的 EIP 动态?

订阅 EIPs Fun 周刊以跟进相关更新,建⽴你与 EIP 之间的连接 ,更好地建设以太坊。

详情
支持以太坊贡献者,推动生态建设
资源
GitHub
支持社区